Be Still My Heart Designs Set 2 - Cards

Designs are created for 5 x 6.5 inch cards

Each Design (except 10-12) gives you  2 basic heart outlines (Color 1 & 2) to allow for quick fabric appliqué of sheer, Mylar, netting or regular fabric. Trim after Color 2. A 2nd idea is to just put your appliqué under the center small design.

 

Designs in package

JJ07Be Still My Heart 100mm--99.3 mm x 88.4 mm (3.91 x  3.48 inches)

JJ07Be Still My Heart 120mm--119.7 x 106.4 mm( 4.71 x 4.19 inches)

JJ07Be Still My Heart 140mm--139.6 x 124.2 mm (5.5 x 4.89 inches)

 

JJ08Be Still My Heart 100mm--99. mm x 81.7 mm (3.91 x  3.48 inches)

JJ08Be Still My Heart 120mm--119.8 x 98.4 mm( 4.71 x 4.19 inches)

JJ08Be Still My Heart 140mm--139.6 x 114.8 mm (5.5 x 4.52 inches)

 

JJ09Be Still My Heart 100mm--99.2 mm x 84 mm (3.91 x  3.31 inches)

JJ09Be Still My Heart 120mm--119.6 x 101.2 mm( 4.71 x 3.98 inches)

JJ09Be Still My Heart 140mm--139.7 x 118.2 mm (5.5 x 4.65 inches)

Clipart by Diddybag.com

JJ10Be Still My Heart 100mm--99.2 mm x 84.5 mm (3.90 x  3.17 inches)

JJ10Be Still My Heart 120mm--119.4 x 101.9 mm( 4.7 x 3.84 inches)

JJ10Be Still My Heart 140mm--139.7 x 113.8 mm (5.5 x 4.48 inches)

 

JJ11Be Still My Heart 100mm--99.2 mm x 91.0 mm (3.91 x  3.58 inches)

JJ11Be Still My Heart 120mm--119.4 x 109.6 mm( 4.7 x 4.31 inches)

JJ11Be Still My Heart 140mm--139.8 x 128.3 mm (5.5 x 5.05 inches)

 

JJ12Be Still My Heart 100mm--99.2 mm x 83.8 mm (3.91 x  3.3 inches)

JJ12Be Still My Heart 120mm--119.1 x 101.6 mm( 4.69 x 4. inches)

JJ12Be Still My Heart 140mm--140.7 x 120 mm (5.54 x 4.72 inches)

 

 

Card 4- Extra stitching & Red fabric for flower center.

These are quick and easy cards to make!

All 6 5inch designs are stitched directly on the blank greeting cardstock.

The cardstock makes 5 x 6.5 inch cards and came with envelopes.

This was purchased from my local craft store

Steps:

1. Hoop a cutaway stabilizer & spray top with Spray adhesive & Use a Sharp needle size 10

2.  Find & mark with a light pencil dot the center front of the card

3.  Lay the card (wrong side down) on top of stabilizer-centering the the design & center of the card

4.  Hold card down firmly in place, start machine off very slowly to 2nd stitch and proceed slowly

5.  Make sure that the card stays flat on the stabilizer or the stitches will go through.

6. When the design is complete, trim excess stabilizer, place layer of cardstock or nice fabric to cover the inside.

Have fun adding your own personal messages to each individual card!

 

Do you have the Pfaff 150 x150 All Fabric Hoop? 

This card fits perfectly in that hoop for the 5inch designs.

 

BACK

The entire contents of this web site are copyright © 2001-2014

Judi Jaksa Custom Digitizer www.customdigitizer.com